Tuesday, 30 November 2021

Loading spout for open truck


The loading spout for tank trucks is made of 2 ducts: a central one to transfer the product from the silo to the truck and an external one to collect dust emissions. According to the applications, the central duct can be different: flexible duct, mild steel cones or telescopic tubes.


The lower part of the loading spout will inch up progressively as required, so as to properly load the product into an open truck or directly on the ground (as required by the application).


A command and control cabinet ensures an automatic loading that complies with normal security requirements ie : motor overheating, automatic lifting, etc...

Technical Data :

Upper part :

Welded iron structure with circular strap to fix the external duct and loading hole
Stud bolts adapted to the existing equipment
Inlet for dedusting
Pulleys with cable guides and scrapers

Intermediate Part :

ø 600mm flexible external duct for duct suction and dust emission protection
Internal part composed by a ø 300 mm flexible duct or mild steel cones or telescopic tubes depending on the application
Motorized lifting device with 3 external cables

Lower part : 

Horizontal frame with rubber flaps
Closing cone including level detection (rotating paddle switch, vibrating rod, pendular sensor,…)

Lifting :

Manual lifting using a hand operated winch or
Motorized lifting device (integrated or remote) with brake, a cable winding rum and top/bottom end of travel limit switches

Command :

Electrical control cabinet
Suspended remote control box

Main Advantages :

Loading spout for open truck or at discharge of a belt conveyor
Dust suction possbile
Available in high flow (800T/h)



9-12 November 2021 - Sertãozinho, SP (Brazil) :

Fenasucro & Agrocana, International Sugar Exhibition.


November 23-25, 2021, Online(Brazil) :

SEMTEC 7º Seminário Técnico da Indústria do Cimento e Cal


20-22 April 2022, Mackay Queensland (Australia) :

ASSCT 2022, 43th Sugar conference, exhibitor and poster presentation.