The P 11 sampler with pneumatic control is set up to extract a quantity of product defined through a vertical pipe. This volume is selected by a twin wheel which controls the cleaning and the tightness of the whole.
The sampling collection is made by the pneumatic piston action within the chamber. It enters into the material flow by putting off the residual product. When the piston is in the flow, the product is collected in the twin wheel. The sample is collected gravity.
Two air intakes are forecast : one for the twin wheel cleaning in the rear position and one for the retention of the product.
Technical Data :
Maximal particle size : 4 mm
Flange mounting
Sampling tube in stainless or mild steel (on demand)
Take out tube in stainless or mild steel (on demand) for the sample recollection
Twin wheel which indicates the sampling volume with tightness toric seals
Double acting jack directly fixed on the body, 5 or 6 bar pressure dry air without oil, 22,5 Ndm3 consumption by cycle
Control of piston positions by magnetic sensors on the jack body
Solenoid valve 5/2 bistable for pneumatic jack
Main Advantages :
Constant volume
No mechanical constraint
Adjustable frequency
Less pollution between two operations
Easy to install
Easy to use
News
20-23 April 2021, Bundaberg (Australia) :
ASSCT Industry equipment exhibition 2021, exhibitor and poster presentation.
September 29-30, 2021, Hotel Manaira, João Pessoa, Paraíba (Brazil) :
SEMTEC 7º Seminário Técnico da Indústria do Cimento e Cal